- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-05-13 11:22 PM . Last Modified: 2023-05-03 12:03 AM
Change an alarm messages
Is it possible to change standart alarm messages?
For example, I have an analog point, wich generates message like this:
"State changed from [Previous State] to [Current State], value is [Current Value] [Reason]"
Can I change it to something shorter? Something like this
"[Current State], [Value]"
- Labels:
-
ViewX
Link copied. Please paste this link to share this article on your social media post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-05-14 10:22 PM
I'm pretty sure that the Event Journal messages (and Alarm Banner messages) are fixed.
Only the State Descriptions can be changed.
The Source can be changed if you configure the Alarm Source entry on the CAlarmObject also.
I'd recommend that you raise this as a feature request in the appropriate forum within this Exchange portal.
Lead Control Systems Engineer for Alliance Automation (VIC).
All opinions are my own and do not represent the opinions or policies of my employer, or of my cat..
Link copied. Please paste this link to share this article on your social media post.
