Link copied. Please paste this link to share this article on your social media post.
Hi,
I'm working on a project where I use a few EDS. (EDIT : EcoStruxture Control Expert XL V16)
And it's the second time I have an issue, the opening application failed.
I'm unable to retrieve the project from the PLC, I have the same error.
I attached a screenshot of my PC, where I have the corrupted project first and under it an old one.
The error says there is a DTM issue, but the DTM Audit tool says it's working fine.
Someone had the same issue ?
Someone found a solution ?
