Extend INET RS-485 controller LAN over RS-485 over Ethernet device possible?

Notifications

Community

Notifications

Categories
Forums
Knowledge Center
Blogs
Ideas
Events & Webinars

Share Your Feedback – Help Us Improve Search on Community!
Please take a few minutes to participate in our Search Feedback Survey. Your insights will help us deliver the results you need faster and more accurately.
Click here to take the survey

Ask the Community

Ask questions, get advice from experts and peers on Digital Automation & Energy Management.

Search in

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Recommended Forums

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Ask the Community

Start a Topic

335

Link copied. Please paste this link to share this article on your social media post.

Hi There

I have an old INET card access system with a new controller in our Parkade. I have CAT6 run in underground conduit and i'm trying to use a pair of RS-485-Over-Ethernet converters with no success. Most of these converters need to know the Speed (9600), Data Size (8), Parity (none), Stop Bits (1), Flow Control (none), however, the 7798C documentation doesn't discuss any other parameter other than Baud Rate. Is this possible using a standard converter or would I need a proprietary Schneider converter?

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

You’ve reached the end of your document

Ask our Experts

Didn't find what you are looking for? Ask our experts!

My Dashboard

Check out the new Feeds and activities that are relevant to you.