Support forum to share knowledge about installation and configuration of APC offers including Home Office UPS, Surge Protectors, UTS, software and services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2801:44 AM. Last Modified: 2024-03-2703:24 AM
I looked up a picture of this unit but I can't see the bottom. Though, similar units just have the door you slide on to one side (towards the outside edge of the unit) with your thumb (or a few fingers) and push/slide. I would make sure your pressing down a little bit on the thumb traction marks in the plastic. Beyond that, I don't know if trying to push down and pry it between the crack in the battery door and the unit casing with a tiny screwdriver would help?
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2801:44 AM. Last Modified: 2024-03-2703:24 AM
I looked up a picture of this unit but I can't see the bottom. Though, similar units just have the door you slide on to one side (towards the outside edge of the unit) with your thumb (or a few fingers) and push/slide. I would make sure your pressing down a little bit on the thumb traction marks in the plastic. Beyond that, I don't know if trying to push down and pry it between the crack in the battery door and the unit casing with a tiny screwdriver would help?