Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

Close
Important Announcement: WELCOME to the Schneider Electric Community! We have moved to a new address: community.se.com — bookmark it today and contact SchneiderCommunity.Support@se.com if you have any questions!
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
82692members
350417posts

UTS10BI: Default Source?

APC UPS for Home and Office Forum

Schneider Electric support forum for our APC offers including Home Office UPS, Surge Protectors, UTS, software and services and associated products designed to share knowledge, installation, and configuration.

Solved
pondcare_apc
Crewman
Crewman
0 Likes
2
122

UTS10BI: Default Source?

This was originally posted on APC forums on 3/19/2013


Hello,

Is the default source for the uts10bi utility even when there is a gen source connected? Will the ATS only switch when the utility is off?

Thanks in advance!


Accepted Solutions
pondcare_apc
Crewman
Crewman
0 Likes
0
122

Re: UTS10BI: Default Source?

This was originally posted on APC forums on 3/19/2013


Thanks for the confirmation! I appreciate it!

See Answer In Context

2 Replies 2
BillP
Administrator Administrator
Administrator
0 Likes
0
122

Re: UTS10BI: Default Source?

This reply was originally posted by Secret on APC forums on 3/19/2013


Yes, the default source for the UTS is line power. The UTS will indicate whether or not is sees generator input, however will only switch to Generator once the Line power falls outside of the predefined operating parameters.

pondcare_apc
Crewman
Crewman
0 Likes
0
123

Re: UTS10BI: Default Source?

This was originally posted on APC forums on 3/19/2013


Thanks for the confirmation! I appreciate it!