Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
In what state do pins 1&4 actually operate? Basically we want to use these contacts to highlight to some external equipment when the batteries run low but can't seem to get them to change over when we would expect them to. For example, if we turn off the AC mains and run on battery, when the batteries start to run low and we get the fast beep we were expecting the contacts to changeover but they don't. Likewise, if we remove the batteries altogether we get no change on the contacts. Note that contacts 2&4 changeover when the mains fail.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.