Circuit braker white button always out...

[Anonymous user]

Hello again, I have a new question about something I saw on the SUA1000i unit i bought last week, the circuit braker on the back of the unit is always out. Is this how it is supposed to be? I mean, in the manual says that it should pop out if the load exceeds the recommended (mine is a lot below!). When I press the little white button, it does not stay in...

Or I just press it to reset the unit if the load is over the recommended. Or normally it should be out, but if an overload happens, then it pops out even more!

This unit is driving me crazy! Everything works fine by the way, but is it wrongly working fine???

The photo shows the current working state of the unit, is it correct???

Thank you!

[Techie_apc]

You are welcome!

Have a nice day!

[Anonymous user]

Hello again, I have a new question about something I saw on the SUA1000i unit i bought last week, the circuit braker on the back of the unit is always out. Is this how it is supposed to be? I mean, in the manual says that it should pop out if the load exceeds the recommended (mine is a lot below!). When I press the little white button, it does not stay in...

Or I just press it to reset the unit if the load is over the recommended. Or normally it should be out, but if an overload happens, then it pops out even more!

This unit is driving me crazy! Everything works fine by the way, but is it wrongly working fine???

The photo shows the current working state of the unit, is it correct???

Thank you!

[Anonymous user · Accepted solution]

Thank you, it is certainly not 1/4" out. So there seems to be no problem. Once again, thank you for your perfect support!