Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.
Posted: 2021-07-12 04:37 AM
This question was originally posted by Luis Fernando on APC forums on 6/18/2015
Hi, I have an AP7900 Switched PDU, and I was wondering if it's possible to configure a sequential OFF triggered by an event of power loss in the UPS powering the PDU.
On the other hand, I want to know what triggers the ON and OFF Delay configured per outlet on the Configuration Tab?
Thanks.
Posted: 2021-07-12 04:37 AM
This reply was originally posted by Angela on APC forums on 6/18/2015
Hello Luis,
Yes, Power on/off delays under Configuration tab will apply when input power is applied to the PDU from a cold start (like when the UPS powering the PDU turns off and back on again) and it also applies if you select the on-delayed or off-delayed commands within the PDU itself. You can bypass those if you select on-immediate or off-immediate.
I hope this clarifies. Let us know if you have further questions.
Posted: 2021-07-12 04:37 AM
This reply was originally posted by Angela on APC forums on 6/18/2015
Hello Luis,
Yes, Power on/off delays under Configuration tab will apply when input power is applied to the PDU from a cold start (like when the UPS powering the PDU turns off and back on again) and it also applies if you select the on-delayed or off-delayed commands within the PDU itself. You can bypass those if you select on-immediate or off-immediate.
I hope this clarifies. Let us know if you have further questions.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.