Smart-UPS SRT 2200: "The battery power is too low to support the load" after battery repl.

[Anonymous user]

Hello,

I have the error "The battery power is too low to support the load; if power fails, the UPS will be shut down immediately." after original APC battery replacement.

The battery have been replaced the 23/09/2020, the error started to show on 12/11/2020.

State of Charge

100.0 %

Runtime Remaining

8min 27sec

Battery Voltage

82.1  VDC

Replacement Battery Cartridge SKU

APCRBC141

Smart-UPS SRT 2200

Last Battery Transfer

Unacceptable utility voltage rate of change

Battery Temperature

25.0°C

Runtime Remaining

8min 13sec

UPS Input

Input Voltage

221.5  VAC @  50.0  Hz

UPS Output

Output Voltage

229.8  VAC @  50.0  Hz

Load Current

2.8  Amps

Output VA

28.4 %

Output Watts

28.1 %

Output Efficiency

battery charging

Output Energy Usage

4194.30 kWh

Battery Status

State of Charge

100.0 %

Battery Voltage

82.1  VDC

Next Battery Replacement Date

24.03.2025

I have already run the "Runtime calibration" from UPS Network Management Card 2 web interface.

Best regards,
Luca