Smart-UPS 700 - calibration after battery replace

[Anonymous user]

Hello, I replaced batteries in my Smart-UPS 700(FIRMWARE : 50.11.I), executed both soft and manual calibrations(http://www.apcupsd.org/manual/manual.html#soft-runtime-calibration), but without effect. UPS goes to 0% 10minutes after AC disconnection and battery charge indicator is strange(after 2 minutes to 30%, then slowly to 0%). How can I calibrate this UPS?

[haarp_apc · Accepted solution]

You could try this if your UPS absolutely refuses to calibrate:
http://www.joeteck.com/apc-repair.htm