RC100 - how to interface to BMS system that communicates via BACnet

karbonphiber_apc · ‎2021-06-28

Anyone have experience/knowledge on how to interface the RC100 to a BMS system that communicates via BACnet?

Message was edited by: karbonphiber

BillP · ‎2021-06-28

unfortunately, the RC network management card doesnt support BACnet at all so i think you will need an SNMP or Modbus to BACnet gateway of some type from what i have heard.

See Answer In Context

BillP · ‎2021-06-28

unfortunately, the RC network management card doesnt support BACnet at all so i think you will need an SNMP or Modbus to BACnet gateway of some type from what i have heard.

RC100 - how to interface to BMS system that communicates via BACnet

RC100 - how to interface to BMS system that communicates via BACnet

Photos

This is a heading