PowerChute behavior during battery calibration

[BillP]

This question was originally posted by Fabio on APC forums on 7/20/2018

---

Hello,

I will soon install SRT3000xli + 2 battery pack SRT96BP + AP9631. I have a question about PowerChute behaviour during calibration. How it will consider the status of UPS? It will see that UPS is "on battery"? If I set a delay time for "UPS on battery" event, will PowerChute shutdown the system even if there is no AC fault? I would like to avoid that PCNS will shutdown the servers during calibration.

Thanks!

[BillP]

This reply was originally posted by Bill on APC forums on 7/20/2018

---

Hi,

PowerChute Network Shutdown will not react to a runtime calibration test being performed on the UPS. 

[BillP · Accepted solution]

This reply was originally posted by Fabio on APC forums on 8/1/2018

---

Thank you!