Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-07-0105:53 AM. Last Modified: 2024-03-0512:07 AM
Percent of Load for Symmetra LX (N+1 vs N+0)
I have two identical LX units installed in one of our server rooms. They are both running the same versions of the UPS firmware, and the same version of the monitoring card (AP9631) firmware (6.1.1)
I just noticed that one is reporting % of load (in watts) at N+0 AND at N+1. The other one is only reporting % of load at N+0. I had been thinking about posting a recommendation that APC include the N+1 figure in a future firmware release. But it seems like you already do (sometimes). I also have several RM 6000 units, and would love to see what the % of load is at N+1 on those units as well.