NMC3 AP9641 (v2.5.3.3) - "Port has been entered incorrectly" when creating Firewall Policy Entries

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

Link copied. Please paste this link to share this article on your social media post.

Hi all,

I'm having trouble with setting up the inbuilt Firewall in our UPS' running NMC3 AP9641 (v2.5.3.3). I'm adding a very simple rule and the GUI parser is giving me an error.

Network Card: NMC AP9641
Firmware: v2.5.3.3 (occurs on earlier Firmware as well)
Error: "Port has been entered incorrectly"
Action: When attempting to add a rule with a "Destination > Port > Other = 161"

Screenshots are attached.

Any thoughts? Is there something simple I'm missing? I've not done anything special. I've just taken one of the examples and attempted to apply it.

Any assistance would be appreciated!

Regards.

Attachments

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!

NMC3 AP9641 (v2.5.3.3) - &quot;Port has been entered incorrectly&quot; when creating Firewall Policy Entries

NMC3 AP9641 (v2.5.3.3) - "Port has been entered incorrectly" when creating Firewall Policy Entries

NMC3 AP9641 (v2.5.3.3) - "Port has been entered incorrectly" when creating Firewall Policy Entries