Minimal modules configuration to start a Symmetra PX2.

[Roio]

Hello, we have a malfunctioning Symmetra PX2. This has gone through several technicians but they haven't been able to diagnose the problem. I think there must be some problem in the communication bus, since apparently the individual modules seem to work.

Currently I am trying to power it with the least number of modules, a power module, a battery pack without and whithin the communication module, a single inteligence module (MIM) or both (MIM/RIM) and the static switch.

I really don't know how to continue with the UPS power on. It currently does not detect any power modules.

The LCD screen does not respond to the commands sent by the keyboard and the alarms are not updated.

But the following information could be obtained via an extra network card.

"No Power Modules Detected"

"Extended Run Frame Fault"

"Output power Turned Off"

"System Start-Up Configuration Fault"

MIM: R State; 00 000 0000 1000 00401 000 1E 0000
RIM: R State; 00 000 0000 1000 00401 000 1E 0000