Mass configure APC devices using Data Center Expert asministrator ?
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-05-2204:53 AM
Mass configure APC devices using Data Center Expert asministrator ?
Hi
Hello, I need to mass configure 100 UPSes with a new Administrator user. I use Data Center Expert 7.9.3 and APC SNMP device configuration, User configuration, Create/Modify User. My problem is that it is only User and password that comes out to the UPS NMC card AP9631. Then you have to go into each UPS and set all the values again and enable the account. Shouldn't DCE be able to configure all the values directly.