MICRO DATA CENTER S SERIES FAILURE TO COMMUNICATE VIA MODBUS WITH SVRPM6KRIL UPS AND ACRMD4KI-1 COOLING IDU

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

256

Link copied. Please paste this link to share this article on your social media post.

i am installing a Micro DC S series and having challenges establishing communication with the UPS and the indoor unit for the cooling unit. For the UPS i have configured the required address on the dip switches of the modbus network card and terminated the cabling, for the cooling unit terminated as per instruction manual. the dispaly can read the MDC's power meter and the Netbotz without any challenges, the UPS and the cooling unit however, are not being picked up.

a manual refered to a rs232 to RS485 converter required to configure the cooling unit and the UPS using a Modbus polling software and the UPS monitoring software respectively. is this the only way to go about this and are there any suggestions on a particular rs232 to rs485 converter and modbus polling software to use to establing communication with the devices.

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!