Launch of Consumer/Home Owner registration process!
We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.
Config Powerchute v5.1 on Advanced Mode for VmWare
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Search in
Improve your search experience:
Exact phrase→Use quotes " "(e.g., "error 404")
Wildcard→Use * for partial words(e.g., build*, *tion)
AND / OR→Combine keywords(e.g., login AND error, login OR sign‑in)
Keep it short→Use 2–3 relevant words, not full sentences
Filters→Narrow results by section(Knowledge Base, Users, Products)
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-01-1406:34 AM
Config Powerchute v5.1 on Advanced Mode for VmWare
Hy,
I have three data centers in data center 1 I have 2 x APC SRT 3000, in data center 2 also 2 x APC SRT 3000 they are not redundant I need 2 x 3KVA because of the power (only 16A plug) In data center 1 and data center 2 VMWare servers are operated with VCenter as VM I would like the whole VMWare environment VM's and ESX host to shut down in the event of a power failure when there is an APC in DC1 or DC2 (VM and ESX host) Should the setup be set to Advanced Option ? What else must be configured under Advanced Option in this case?