BX1200-CN won't switch to AC power after I replaced the battery
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-04-1701:44 PM
BX1200-CN won't switch to AC power after I replaced the battery
I just installed a new RBC32 battery in my BX1200-CN and when I plug it into the wall and hit the button the top green light flashes for a second and then the yellow (battery power) light comes on steady instead. Any idea what is wrong? I first plugged it into the wall and let it sit for over 8 hours before I hit the button so it should be recharged. This started when we had a power outage overnight and I never checked on the UPS until much later after power was restored. When I hit the button it would continuously switch between the green and yellow lights so I ordered a new battery.