Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-03-1103:39 PM
APC AP9211 and Management Card AP9617 or AP9606
Hi Ya'll from Texas
I have a few Masterswitches and Cards I decided to put back into service for a project.
The AP9611 had a AP9617 card in it (Not sure is that's allowed) and after setting the IP and accessing the menus and web interface I could not see the Outlets in the Device section.
So here's where it gets messy !
I found the AP9617 didn't have the right app installed, it had a UPS app on it.
So after messing with it I upgraded it and then Bricked the card
Now both led's on the Card are solid Orange ?
So now the question is how to unbrick it ? I assume it stuck in boot loader mode ?
What should be the correct firmwares to use aos and app for the switch
Any direction would be appreciated I have the serial cable for communicating with COM port and Teraterm downloaded and thinking XMODEM upload the aos file into the card ?