AP9630 NMS2 v7.1.2 Test e-mail failed; SMTP configuration error. Last Server Response: 220 2.0.0 Ready to start TLS
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-11-2212:47 PM
AP9630 NMS2 v7.1.2 Test e-mail failed; SMTP configuration error. Last Server Response: 220 2.0.0 Ready to start TLS
The subject says it all.
I've tried everything and I cannot get a successful SMTP test.
I am running the very latest AOS (v7.1.2) and Bootrom (v1.0.9)
EMail server works with everything else using SSL/TLS
Seems like this issue has been reported a lot over the years. Any advice would be appreciated.
Always get the same result for test result:
Test e-mail failed; SMTP configuration error.
Last Server Response
220 2.0.0 Ready to start TLS
Configuration of server is (email addresses and server addresses in config below are examples) [NetworkEMAIL] ; To change an E-mail Recipient's Password use the ; EmailReceiver#Password keyword where # is the number of the ; recipient. i.e., EmailReceiver1Password=password ; To make a Recipient use the common Server settings, use ; EmailReceiver#UseCommon=enabled EmailFromName=ups@example.net EmailServerName=secure.example.net EmailServerPort=587 EmailServerAuth=enabled EmailServerUsername=xyz@example.net EmailServerSSLMode=Optional EmailServerCertRequired=disabled EmailServerCertFilename="" EmailReceiver1Enable=enabled EmailReceiver2Enable=disabled EmailReceiver3Enable=disabled EmailReceiver4Enable=disabled EmailReceiver1Address=xyz@example.net