Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2806:11 AM. Last Modified: 2024-03-1802:39 AM
ACRP102
I have a number of relay cards that are causing 'Heater # fault ' alarms. I have replaced some of these cards on the cooling units and the alarms go away. This only occurs only when the 'Heat Assist option' is turned on. Is there a known issue with these cards regarding this alarm issue?