Square D Power Link G3 and G4

Notifications

Launch of Consumer/Home Owner registration process!
We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.

SpaceLogic C-Bus Forum

Schneider Electric forum about the C-Bus platform to get support and share knowledge including Network Automation Controller (NAC), Application Controller (AC) at selection, installation and troubleshooting sides.

Search in

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to SpaceLogic C-Bus Forum

Start a Topic

827

Link copied. Please paste this link to share this article on your social media post.

Hi,

I'm not sure if this is the correct place to ask about the Square D Power Link G3 and G4, if not please point me in the right direction.

I have a NF2000G3 controller and I have run out of inputs and schedules. There are only 16 inputs and 16 schedules available, and the rest are greyed out. What is the best way to add more inputs and schedules?

I think the G3 controllers have been discontinued and there is no replacement for it. If I need to add a new controller, would I have to use a NF3500G4? I'm also using the LCSv1 software, is the G4 compatible with LCSv1 or would I need to upgrade to the LCSv2 software?

Thanks

Jason

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

You’ve reached the end of your document

Ask our Experts

Didn't find what you are looking for? Ask our experts!

My Dashboard

Check out the new Feeds and activities that are relevant to you.

To The Top!