Schneider Electric forum about the C-Bus platform to get support and share knowledge including Network Automation Controller (NAC), Application Controller (AC) at selection, installation and troubleshooting sides.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2021-06-2210:05 PM
Hi there,
When it comes to displaying the Time and Date on an eDLT, even if only time is being displayed, the C-Bus network needs to know both time and date.
Assuming you have created a Time/Date widget on the eDLT already, you can now go to the physical eDLT and enter into the tools page by pressing and holding the left side of button 5 while simultaneously double tapping the right side of button 1.
This will provide you with a menu where basic settings of the eDLT can be changed, including time and date. Fill out these settings and exit tools mode using the buttons on the eDLT.