- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
Is anyone developing a Smart Connector to Vista for alarming to SBO?
Have a customer that has Vista and transitionig to SBO which will take a few years, they would like to have all of their alarms in SBO as they go through transition.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
TAC Vista? There’s a TAC Vista EWS interface available on Download Center from R&D. Not a SmartConnector.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Link copied. Please paste this link to share this article on your social media post.
Hi Greg.
Just to expand upon what Benji said. You don't need to create a SmartConnector extension for this as another solution already exists. You will need to install and configure the EWS Interface for Vista (linked above), and then create a an EWS Interface in SBO that points to it. You should then receive alarms in SBO from Vista.
Regards,
-Jeff

