Protection & Control
Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.
Link copied. Please paste this link to share this article on your social media post.
Good day guys, please tell me if I should use Graphic Editor or Graphic Builder to draw Power operation single line diagram
Link copied. Please paste this link to share this article on your social media post.
Hello @John_Archer1 ,
You can draw single line diagram either in Graphic Editor or Graphic Builder both. Graphic Editor pages are limited to the PO thick client and can not be displayed on Webhmi. For Webhmi pages, you need to create them in Graphic Builder. I hope this answers your query.
Regards
Dhruv
Link copied. Please paste this link to share this article on your social media post.
Hello @John_Archer1 ,
You can draw single line diagram either in Graphic Editor or Graphic Builder both. Graphic Editor pages are limited to the PO thick client and can not be displayed on Webhmi. For Webhmi pages, you need to create them in Graphic Builder. I hope this answers your query.
Regards
Dhruv
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.