Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
hi guys I am reading the LED light data of easergy P3U30 relay to PowerLogic T300 (formerly named Easergy T300) via IEC101 protocol. However, the value of the LED light data value 1 does not change. How to fix it? The other relay led info I'm reading is OK. Have you ever faced such a problem?
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Hello:
pls enable LED change event then try again:
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.