Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Easergy P3U30 Read LED data to t300 with iec 101 protocol
Protection & Control
Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
hi guys I am reading the LED light data of easergy P3U30 relay to Easergy T300 via IEC101 protocol. However, the value of the LED light data value 1 does not change. How to fix it? The other relay led info I'm reading is OK. Have you ever faced such a problem?
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Hello:
pls enable LED change event then try again:
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.