Disconnects

[MB3030]

Our team stumbled upon a question that may be a Schneider Electric's manufacturers guideline answer. Can a 600V 400A fusible disconnect feed a 120/208V 400A panel? Knowing no matter what it should not allow more than 400A to pass through, the question may not be about protection but rated use within the system. Any advise would be greatly appreciated.

[Araceli_Monje · Accepted solution]

This question should be sent to our expert colleagues in Low Voltage Line of Business (Power Products). Could you please connect with your local SE representative so you can be guided to the right person to be contacted for this question?, thx.