Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2024-12-1807:09 AM
Disconnects
Our team stumbled upon a question that may be a Schneider Electric's manufacturers guideline answer. Can a 600V 400A fusible disconnect feed a 120/208V 400A panel? Knowing no matter what it should not allow more than 400A to pass through, the question may not be about protection but rated use within the system. Any advise would be greatly appreciated.