ATV 630 Digital Input

Notifications

Protection & Control

Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Protection & Control

482

Link copied. Please paste this link to share this article on your social media post.

Hello community / I'm somewhat new to this world of automation and recently acquired an Altivar 630 frequency drive. I want to use it for a water pumping system application, but I have an issue. I'm using a Profinet communication module to connect it to an S7 1500 PLC. However, I'd like to know if there's a way to deactivate the local mode of the drive if there's no digital input on any terminal (for example, if there's no '1' on input DI2) or if it's possible to force the drive to stop if that condition is not met in local mode. I have configured the drive in the I/O input profile to communicate with the PLC.

I would greatly appreciate it if someone knows how to do this.

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!