Load flow studies

[High_Voltage62]

Hello,

I am encountering an issue with calculations in the EcoStruxure Power Design software. Specifically, with single-phase loads, when I set the feeder connection type to "automatic" for load flow analysis, after the calculations, in the details tab, under the "DESIGN CURRENT" section, I cannot see how the software has automatically distributed the load across the phases. It only shows the total current with the "IN" symbol, and the phase currents are displayed as zero.

Please advise on where I can find information on how the load distribution is performed in the software and how the single-phase loads are automatically assigned to each phase, and how I can view this assignment.

Thank you.

[Manon_Chaboud]

Hello @High_Voltage62, thank you for your post, we'll come back to you!