Connection lines in EcoStruxure Power Design?

[Emilio1]

How can I draw connection lines (where they are electrically permitted, of course)?

[Genghiz · Accepted solution]

Hello,

Thanks for reach us through the ‘EcoStruxure Power Design Forum.’

Connection line:

The connection line between the two switchboards can be created as follows.

Here, we have taken the example for the feeder circuit (Protection-Cable), which is connected between the two switchboards.

• The protection is changed as ‘inhibited.’

Protection to Inhibited

• The cable is changed as ‘direct-link.’

Cable to DirectLink

The outcome will be shown as follows as a ‘connection line’ between the two switchboards, which is electrically connected.

Connection line is achieved

we hope, the above suggestions would help you to resolve your query. 

Regards,

Team - Ecodial Expert Support.

[Emilio1]

Thanks buddy.

[Genghiz]

Thanks for your understanding and acceptance.

Kindly please feel free to come back; on the topics related to the EcoStruxure Power Design.

[Pradeeb]

Inhibited Option is not listed in the software. Kindly advise

[Genghiz]

Hello Pradeeb, 

As explained above, these options are available at the application. 

• The LV protection is changed as ‘inhibited.’
• The LV cable is changed as ‘direct-link.’

If you have a concern on a specific circuit, then kindly please come back.

Regards,

Team - Ecodial Expert Support.