TeSys T LTMR Ethernet communication loss don't work.
Motion Control Forum
Schneider Electric forum for Motion Control solutions, including Lexium MC12 & Cobot, Modicon PLC, PacDrive, Ecostruxure Machine, … from design, implementation to troubleshooting and more
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-01-0303:05 AM
TeSys T LTMR Ethernet communication loss don't work.
Hellow everybody. I have a problem whith LTMR27EFM, when we change to remote control (I.6 input ON) with Ethernet IP from PLC CompacLogix is working (run, O.1, O.2 e.t.c) but when I physicaly imitate communication loss with disconecting the wire UTP, the outputs motor start LO.1 and LO.2 are not Shout down or not swhitching but LO.1 and LO.2 are state "ON" (comand from CompacLogix).
Parametr network port fallback action setting = LO1, LO2 off