Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
Hi,
First of all, thanks in advance for those who support and advises.
I have a Modbus/TCP operational network. Last week a NOE 771 01 on one of my Hot Standby PLC System, Standby PLC stopped communicating. On its display the indication Fault, Kernel and Appl were illuminated. I replaced the card with a new one. It normalized but after a while it happened again on the same PLC. I tried with 3 new NOE cards but the fault remains. When I tested the card on a test system on my desk it seemed to be ok. The firmware and configuration is checked to be correct. What can cause this fault? Appreciate very much your advise. Thanks.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.