Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
Hello everyone,
First of all this is my first time working with Schneider Electric and its software and equipment so please go easy on me
Until now I have only been working with Siemens equipment but for my next project will need to work with Schneider, precisely m580 PAC.
Pre commissioning means that I will be mainly doing io check and adjusting instruments in field and via Control expert software tool. Now
can anyone tell me some good course or channel where I can learn a little bit more about those things. Basically I need beginner steps for
this PLC, to learn how to set IP address, how to create VAT table, how to force and check inputs and outputs, the hardware part as that is
what my part of the job is. Especially the part about checking and forcing inputs and outputs is important to me so for this i would really
appreciate your help.
Thanks very much in advance and best regards to all!
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.