M221 Firmware Upgrade Issue - Machine Expert Basic 1.3 Build 215

Notifications

Modicon PAC Forum

A forum for topics related to the scope of Modicon PAC offers and ecosystem along the whole lifecycle: Modicon M580 and 340, EcoStruxure Control Expert, EcoStruxure Process Expert (Unity Pro) and more.

Search in

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Modicon PAC Forum

Start a Topic

684

Link copied. Please paste this link to share this article on your social media post.

My laptop recently ugraded to Machine Expert Basic 1.3 (build 215) using the software update tool.

Since doing this I have experienced the following problems when using the software with 3 no. TM221ME16R PLCs as follows:

One PLC upgraded OK using the USB port and allowed the "PC to Controller" program transfer using the USB port.

One PLC upgraded OK using the USB port but would not allow further comms (green connectivity progress bar stopped at 86%) so the Ethernet port was used for the "PC to controller" program transfer.

One PLC upgraded OK using the USB port but would not allow further comms (green connectivity progress bar stopped at 86%) and the Ethernet port was disabled so no further comms can be made to the PLC.

Any advice will be greatly appreciated.

Thank you.

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

You’ve reached the end of your document

Ask our Experts

Didn't find what you are looking for? Ask our experts!

My Dashboard

Check out the new Feeds and activities that are relevant to you.

To The Top!