How to change the position of an automatically generated MC12 system in Machine Expert Twin?

Notifications

Machine and Motion Control Forum

Support forum for Machine and Motion Control solutions, including Lexium MC12 and robotics, PacDrive, Modicon PLCs and I/Os, EcoStruxure Machine Expert Twin, … - from design, implementation to troubleshooting and more, by Schneider Electric

Important Note

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Machine and Motion Control Forum

Informational

280

Link copied. Please paste this link to share this article on your social media post.

Having trouble with changing the position of an automatically generated MC12 system in Machine Expert Twin?

No worries, we have prepared a detailed FAQ that addresses this issue. It explains step-by-step how to modify the position of an automatically generated MC12 system in Machine Expert Twin.

Here's the link to the FAQ:

How to change the position of an automatically generated MC12 system in Machine Expert Twin?

Follow the instructions in the FAQ, and it should guide you through the process of adjusting the position of your MC12 system.

If you encounter any further difficulties, feel free to ask for further assistance below ⬇️ Good luck!

Replies 0

li.media.uploader-dialog.title

li.media.uploader-dialog.tabs.upload li.media.uploader-dialog.tabs.upload
li.media.uploader-dialog.tabs.web li.media.uploader-dialog.tabs.web
li.media.uploader-dialog.tabs.saved li.media.uploader-dialog.tabs.saved

li.media.album-selector.label

li.media.album-selector.label

li.media.album-selector.title

li.media.album-selector.new.title

li.media.image-upload.drag

li.media.image-upload.drop

li.media.image-upload.mobile.instruction

li.media.image-upload.no-flash

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!

upload

Translating the page…

The page is currently translating. Please wait.

How to change the position of an automatically generated MC12 system in Machine Expert Twin?

How to change the position of an automatically generated MC12 system in Machine Expert Twin?

li.media.uploader-dialog.title

This is a heading