Support forum for Machine and Motion Control solutions, including Lexium MC12 and robotics, PacDrive, Modicon PLCs and I/Os, EcoStruxure Machine Expert Twin, … - from design, implementation to troubleshooting and more, by Schneider Electric
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-02-1005:52 AM
HMISCU8B5
Hello, how to downgrade the firmware of the HMISCU8B5 HMI?
By mistake, we flashed the HMISCU8B5 with Firmware 6.3 via VijeoDesigner 6.3 and the project intended for this HMISCU8B5 console controller is carried out under SOMACHINE 4 (so VijeoDesigner embedded V6.2)
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-02-1212:46 AM
Hello, I already tried to transfer the project via a USB key.
Error message: "The automatic installer detected an error. There is a mismatch between the target types or versions of Vijeo Designer and the HIM"