Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Cannot connect to M241 over ethernet
Machine and Motion Control Forum
Support forum for Machine and Motion Control solutions, including Lexium MC12 and robotics, PacDrive, Modicon PLCs and I/Os, EcoStruxure Machine Expert Twin, … - from design, implementation to troubleshooting and more, by Schneider Electric
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Hello!
I unboxed new TM241CE24T/U and I upgraded Firmware to v5.1.9.21 for using with machine expert v2.0.
My problem is that I can connect to PLC over USB but not over Ethernet, even I can ping to its IP Address and I can access to Plc over web page.
Can You help me please ?
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Hi @MedSelmi ,
If you are trying to connect to the M241 via ethernet or USB it is important that the gateway is activated.
In the case of the Ethernet connection I always add the device ip address in the "Statis Remote Connections" like this:
The device it is shown as "Connected as client".
Verify also that your laptop/pc is in the same network as the controller.
Best regards,
Letomas
Link copied. Please paste this link to share this article on your social media post.
Hi @MedSelmi ,
If you are trying to connect to the M241 via ethernet or USB it is important that the gateway is activated.
In the case of the Ethernet connection I always add the device ip address in the "Statis Remote Connections" like this:
The device it is shown as "Connected as client".
Verify also that your laptop/pc is in the same network as the controller.
Best regards,
Letomas
Link copied. Please paste this link to share this article on your social media post.
why is mine always like this, i have been waiting for it for quite a long time but still can't connect
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.