How to connect HMIST6400 to TM221CE24R PLC?

[jhonut]

Hello,

I'd like to connect a HMIST6400 (programmed with ESOTE) with a TM221CE24R PLC (programmed with MachineExpert Basic).

I have exported the PLC symbols, but MEB allows only the .csv format which is not recognized by HMI.

How could I connect these two devices?

[Bastian_Schmitz · Accepted solution]

The way is easier than you expect.

Add a SE Modbus TCP driver (or SIO)

And then import the Basic file via symbol import

[LeTomas]

Dear @jhonut ,

I have made the next video of how to connect the HMISTO7 to a M221.... is the same for the HMIST6****:

https://schneider-electric.box.com/s/av7nek0zbdltp6oh7qfuysfiimx2uomh

Best regards,

Letomas

[jhonut]

Thanks for your reply, @Bastian_Schmitz !

I have done as you suggested but I get an error: "Invalid device address. Enable or disable IEC address mode in the equipment." How should I do this? It's true that I don't use Modbus addresses but memory addresses.

Later edit. I have seen the video suggested by @LeTomas and I've how he's done it.