Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
TESTS PERFORMED:
- ESTABLISH COMMUNICATION ( communication test) is correct.
- If it responds to the ping command (default IP).
- Connected by USB and ethernet cable
The following message is displayed When I connect to the PLC :
PLC --> connect
Test connection: Ok
Unlock security.
Mode programming
Note:
All I/O modules have been loaded, but the message persists.
Please help !!
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.