Hysteresis on Out of Range Limits

Invite a Co-worker

Send a co-worker an invite to the Exchange portal.Just enter their email address and we?ll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

210

Originally published on Geo SCADA Knowledge Base by sbeadle1 | June 09, 2021 08:46 PM

📖 Home Back
Hysteresis prevents that point changing state when moving towards the normal state by specifying the amount by which it must cross the limit before changing state.

ClearSCADA is designed such that hysteresis applies to the four alarm limits (High High, High, Low and Low Low), but does not apply to the zero scale and full scale range processing. This means that when the point comes back into range, it is immediately valid.

Go: Home Back

Author

sbeadle1

To The Top!

Subscribing is a smart move!

You can subscribe to this forum after you log in or create your free account.