T300 connected to P3 via 61850

[elnur]

Dear collegueas.

I receive conf error message when try to connect P3U to T300 via 61850. I configure 61850 using Build SCD option and download to T300 just to test but fail getting error message. please see below pic.

Can you share step by step instruction how to configure  P3-> T300 connection via 61850?

Thanks in advance,

[Romain_Polette · Accepted solution]

Hello @elnur , 

This board is only for discussing Panel Server or former range of gateway topics (Link150, PowerTag Link, etc).

Please ask on the dedicated forum if your question is related to protection relays or Easergy Builder:

• https://community.se.com/t5/Protection-Control/bd-p/protection-relays-forum

Regards,