Ask our Experts
Didn't find what you are looking for? Ask our experts!
Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…
Search in
Link copied. Please paste this link to share this article on your social media post.
Hello, I need support regarding an issue with SCADAPACK 474,
As a Modbus RTU Master, It's communicating with only one slave at a time.
when I disconnect that slave, communication is established with the next one.
I'm using Baud rate 9600, frame:8 bits, even parity
The slave are 3 ZigBee modules. I checked the slaves ID and it was ok as configured in the SCADAPACK.
I tried to increase and use different scan rates time for the slaves but no results.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.