Other Documentation Com'X 200 Metering and Data Acquisition System Installation Guide v1.1

Notifications

Gateways and Energy Servers

Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Gateways and Energy Servers

584

Link copied. Please paste this link to share this article on your social media post.

This document provides instructions for installing and setting up the metering and data acquisition system using a Com’X 200 as the main data aggregator of the system. The instructions are presented in the order in which they are to be carried out. They supplement the assembly or installation documents supplied with the equipment and the specific installation guides for each product. The installation guide presents general wiring rules, recommendations about wireless network, installation recommendations of the Com’X 200, and cabling schemes of devices connected to a Com’X 200:

monitoring devices and electrical equipment
Modbus RS 485 / Ethernet TCP/IP communication gateway
GPRS modem
Wi-Fi modem
maintenance
checklist
troubleshooting and diagnostics

This guide is intended for the electrical contractor or integrator in charge of installing and configuring the energy management solution.

Replies 0

To The Top!