ComX 510 IP or Slave routing - remote device connection
Gateways and Energy Servers
Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2019-01-0310:30 AM
Hi Sven,
Yes, you can configure the Com'X to have remote devices connected to it and then you can read all of these devices through the Com'X. However, in the Com'X, this feature is turned off by default and you have to enable the Gateway feature before you can read data from downstream devices.