Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
SELECTIVITY BETWEEN NW MIC6.0E ACB WITH CVS MCCBs
EcoStruxure Power Design Forum
Schneider Electric support forum to share knowledge about installation and usage for Electrical Network Design and Calculation Software (Ecodial, Ecostruxure Power Design).
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Hi,
I got No selectivity report between NW (Mic 6.0E) ACB & CVS MCCBs. But when i changed the ACB trip unit to 2.0E, I got Total Selectivity.
Anyone please expalin why there is no coordination between NW 6.0E trip unit ACB with CVS MCCBs?
I have attached the Time-Current Curves for reference.
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Hello Shameek Mohamed,
Thanks for contacting us.
This issue has been fixed in INT 5.2.0 version,
Please find the download link below for INT5.2.0.
https://www.se.com/in/en/product-range/61013-ecostruxure-power-design-ecodial/#software-and-firmware.
Thanks & Regards,
- Ecodial Expert support team.
Link copied. Please paste this link to share this article on your social media post.
Hello Shameek Mohamed,
Thanks for contacting us.
This issue has been fixed in INT 5.2.0 version,
Please find the download link below for INT5.2.0.
https://www.se.com/in/en/product-range/61013-ecostruxure-power-design-ecodial/#software-and-firmware.
Thanks & Regards,
- Ecodial Expert support team.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.