EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-05 01:55 PM
This question was originally posted on DCIM Support by BJ Muckian on 2018-11-11
(CID:134695982)
Posted: 2020-07-05 01:55 PM
This comment was originally posted on DCIM Support by Stine Hansen on 2018-11-12
Hi BJ,
I'm not sure if you meant to search or ask a question. If you were searching, try looking into StruxureWare Data Center Operation: Capacity.
If you're asking a question, please add a little more detail to what you're trying to achieve.
Thanks,
Stine
(CID:134696262)
Posted: 2020-07-05 01:55 PM
This answer was originally posted on DCIM Support by Jef Faridi on 2018-11-20
Hi BJ,
Assuming we want to view the power dependency/properties/settings etc. of the installed/modeled devices in planning mode (1), then it can be viewed in Power overlay (2) and/or using the Power Dependency tab (3):
Kind regards
(CID:136153708)
Posted: 2020-07-05 01:55 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.