EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-05 04:04 PM
This question was originally posted on DCIM Support by Yaron Davidof on 2019-01-13
hello
Where can I find the list of equipment supported by
APC DCE (sensors, PDUs and protocols) ???
(CID:137732065)
Posted: 2020-07-05 04:04 PM
This answer was originally posted on DCIM Support by spezialist on 2019-01-13
Dear Yaron Davidof,
I have never seen such a list of DCE supported equipment for end customers (this is not surprising, since the number of DCE supported equipment is constantly increasing).
Therefore, there is a special resource Device Support, where you can simply find and check the equipment you need. And if your equipment is not yet DCE supported, you can request its support for free.
If you have more questions, please ask.
With respect.
(CID:137732115)
Posted: 2020-07-05 04:04 PM
This answer was originally posted on DCIM Support by Ed Tarento on 2019-01-14
Yaron
DCE will monitor anything with an SNMP agent, or modbus IP devices, and anything else that can be converted to ether of these 2 protocols, e.g. modbus/RTU. Having said that, DCE is best monitoring APC/SE data centre devices. It wouldn't be my first pick to monitor say Cisco equipment or Servers or Printers, even though it may be technically possible.
Cheers
Ed
(CID:137732252)
Posted: 2020-07-05 04:04 PM
This comment was originally posted on DCIM Support by spezialist on 2019-02-09
Dear Yaron Davidof,
Tell us, please, did you solve your question or not?
With respect.
(CID:139693969)
Posted: 2020-07-05 04:04 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.